TOUCH Builder gel Crema, 15 ml

Builder Gel Crema is a modeling gel with a medium, creamy consistency that occupies an intermediate position between builder liquid and classic builder gel in the TOUCH system. The material combines the control of dense gels with the flexibility of more liquid textures, allowing comfortable work in various techniques: from strengthening to modeling, extensions on lower and upper forms. The gel is easily picked up with a brush, moves softly during application, and spreads evenly over the nail plate without sudden dips or uncontrolled flow.

The formula is thixotropic: the material becomes more mobile under the brush but retains its shape after application and does not flow into the cuticle or sidewalls. This makes it possible to work at a comfortable pace and control the process without rushing. In a thin layer, the material remains elastic, while in architecture it forms a stable coating without the risk of cracks. Builder Gel Crema has no strong odor and is suitable for daily salon work, where balance between speed, control, and stable results is important. Available in 15 ml and 30 ml volumes, without a brush.

Features and benefits:
• Medium, creamy consistency
• Combination of control and flexibility in work
• Comfortable pickup with a brush
• Even distribution without sudden spreading
• Thixotropic formula — moves under the brush but does not flow, allowing application on several nails at once
• High-temperature gel ensures good arch pinching
• Retains shape after application
• Suitable for strengthening and modeling
• Stable in architecture, without cracks
• Comfortable to use without strong odor
• Adapted to salon work pace

Work features

Application method:
• Surface filing with a 180 grit file
• Degrease the nail plate with fresher
• Apply dehydrator
• Apply ultrabond/primer with a semi-dry brush on the nail tip, avoiding the skin
• Apply hold base or smart rubber base as a thin underlayer
• Cure in the lamp for 60 seconds
• Remove the sticky layer of hold base or smart rubber base;
• Perform extension or strengthening of the nail plate

Features:
When strengthening, be sure to file the natural nail from the inside. Shape filing should be done after applying the hard material. During polymerization, a warming sensation may occur, so for comfort it is recommended to use the reduced power mode of the lamp. If necessary, the client may take a short pause during curing.

Thickness: for strengthening in the middle of the nail — 0.5–0.7 mm; for strengthening the entire nail or extensions: cuticle offset — 1 mm; apex — 1 mm; free edge — 0.7–1 mm.

Curing time: in LED lamp 48W — 60–120 sec.